Change language

FOLLOW

Lift shaft

All the products in the line Lift shaft

Lift shaft

 

 

The lift shaft is made up of the Modulo formworks of both sections 100/120 and of four bi-tapered blocks, located in the inner corners. In the external part, formworks joined in the traditional way are used: clamps or pin and wedge, while the standard vice is used for the corner.

For the following casting it will only be necessary to reciprocally slide the bi-tapered blocks, placed in the corners, to aid the dismantling and their further re-use.

The upper casting will be made using the mould supporting stirrups positioned on the previously obtained bar passage hole.

The elevator housing is made with the use of biconical blocks on the inner form and standard formworks that allow the sliding out of the whole formwork form, which is also suitable to make underground vanes of any kind.

 

 

 

Lift shaft

Download catalogue / Data sheet

Download Forms

X


Before downloading the document please fill the form with your data.

I have read the information note on privacy and I authorize the processing of my personal data.


Dimensions and weights available

Dimensions and weights


construction examples

CONTACT US


I have read information note on privacy and I authorize the processing of my personal data

®2017 CORPORATE HEAD OFFICE
Faresin Building Division S.p.A.
- Via della Meccanica, 1 - 36042 Breganze (VI) Italy - P.IVA IT 02470320249 - Tel. +39 0445 300300 - Fax. +39 0445 874748 - info@faresinbuilding.com - sitemap - ita - eng - fra - deu - esp - por - rus - ara - rom